I
had planned to have this video up on time like a normal Sunday
morning. Then I messed up the project and had to start my filming
over. I had worked on the door to the stove over the course of 3 days
(Wednesday through Friday) and I had the door complete and ready to
install on the stove. This we Friday afternoon. That is when I
discovered I had cut the door 1/8” too wide to fit! I couldn't
believe it, and I have no idea why in all that time I hadn't dry fit
the door on the stove to make sure it fit. I guess I was distracted
and busy with too many things at one time. Anyway, I had to start all
over. So first thing Saturday morning I started all over and you can
be sure I measured more carefully this time and I dry fit the door at
pretty much ever step of the way to make sure it was going to still
fit. So learn from my mistake, be sure to check your measurements
and do a dry fit!
Because
of my blunder I didn't get as far as I wanted to this week.
We
need very few materials this week here is the list of what you need
to cut:
Foam
core (door)
2
⅝” by 1 ½”
White
Card stock:
¼”
strip (to cover cut edge of window opening)
2
½” by 2 ¾”
⅞” white
ribbon cut about 1 ½” to 2” long (hinge)
clear
plastic packaging a bit bigger than window opening
Gray
Card stock:
2
½” by 1 ⅜”
Cut
the window opening ½” plus a tiny bit in from each edge just make
sure it doesn't show from outside.
And
a piece slightly smaller than bottom of oven to cover ribbon hinge.
No comments:
Post a Comment